Service

Ceramic components for global applications

  • Home
  • Materials
  • Alumina Ceramic Machining (Al₂O₃)

Alumina Ceramic Machining (Al₂O₃)

95% to 99.9% purity grades and precision machining

Alumina ceramic components

Alumina is a widely used engineering ceramic with high hardness, wear resistance, electrical insulation and chemical stability. SHENTIN supports ceramic component production from forming and sintering through precision machining, with material selection based on your application.

Alumina Grades and Applications

Properties and applications vary by purity. Confirm the required specification against the drawing and material certificate.

Purity Key characteristics Example applications
95% alumina Wear resistant and economical General machinery parts, textile guides, wear liners and nozzles
99.5% alumina High electrical insulation Electronic substrates, vacuum insulators and back-end semiconductor parts
99.9% alumina High purity, low impurities Front-end semiconductor and plasma-process components; contamination requirements require review

Typical Applications

  • Electronics and semiconductors: vacuum chamber insulators, wafer carriers and high-voltage insulation.
  • Industrial machinery: pump shaft seals, wear-resistant guides and structural supports.
  • Chemical and textile equipment: valve components and textile guide rollers.

Key Properties

  • Hardness and wear resistance: useful for wear parts; service life depends on the material, mating surfaces and operating conditions.
  • Electrical insulation: suitable for insulating components, subject to voltage, temperature and environmental review.
  • Thermal and chemical stability: material grade and exposure conditions determine suitability.

Reference Ceramic Material Properties

Property / material Alumina Zirconia SiC Si₃N₄ AlN
Density g/cm³ 3.9 6 3.2 3.3 3.2
Thermal conductivity W/(m·K) 28 1.8 126 27 160
Thermal expansion 10⁻⁶/°C 8 10.1 4 2.3 4.4
Microhardness kgf/mm² 1600 1400 2300 1500 1200
Specific heat J/(kg·K) 800 400 700 700 730
Elastic modulus GPa 370 200 410 310 340
Tensile strength MPa 262 700 400 524 400
Compressive strength MPa 2600 1850 3900 2500 2070
Flexural strength MPa 380 690 550 780 360
Fracture toughness MPa·m½ 3.6 9.5 4.6 7.7 2.6
Poisson’s ratio 0.23 0.26 0.19 0.24 0.25
Melting point °C 2053 2700 2700 1900 2400

Values are reference figures from the original page, not guaranteed specifications. Properties vary by grade, processing, batch, test method and operating conditions. Use supplier specifications and inspection data for material selection and acceptance.

Machining Capabilities

  • Large components: support beams and guides over 1,000 mm may be assessed; dimensions and distortion depend on the part and drawing.
  • Surface finishing: precision grinding and polishing can be assessed. The original page lists Ra < 0.2 µm; achievable finish depends on the part and measurement conditions.

Discuss Your Alumina Component

Send SHENTIN your drawings, operating temperature, chemical exposure and loading conditions. We will review material and machining options.